The floor heating water divider is composed of two parts, the water divider and the water collection, collectively called the floor heating water divider. The water divider is a water distribution device used to connect the water supply pipes of various heating pipes in the water system. The water collector is a water collection device used to connect the return pipes of various heating pipes in the water system. The main accessories of the floor heating water separator are water separator, water collector, inner joint head, filter, lock valve, articulated head, valve, exhaust valve, heat meter.

Multiple locations can be selected

In fact, the water separator can be installed in many locations, as long as the design is reasonable. For example, it can be designed to the bathroom, which has a waterproof layer. And innocent. Secondly, the water separator can also be installed outdoors, so that the purpose of installation is mainly to facilitate later maintenance and repair, such as on the balcony of the kitchen, if there is a dripping phenomenon, it can also be drained through the floor drain.

Generally installed on the wall below the wall-mounted boiler: the floor heating water separator is generally installed on the wall below the wall-mounted boiler, and the location is required to be easy to operate and easy to drain. Because the outlet water and the return water are each set, the two must be staggered to a certain position, so that the outlet pipe and the return pipe of the same route can be matched and matched. The height should be close to the ground, and the installation should be firm and reliable, and not easily collided and dislocated by other objects.

Floor heating water separator installation requirements

1. The water separator is installed in the wall and special box, usually in the kitchen room;

2. The valve below the water collector should be installed horizontally at a distance of more than 30 cm from the floor;

3. The water supply valve is installed in front of the water separator, and the return valve is installed behind the water collector;

4. The filter is installed in front of the water separator;

5. Distributor connection sequence: connected to the water supply main pipe-lock valve-filter-ball valve-three-way (temperature, pressure gauge, interface)-water separator (upper bar)-geothermal pipe-water collector (lower bar )—Ball valve—connected to the return water main.